slenderness

英 [ˈslɛndənəs]

美 [ˈslɛndərnəs]

网络  细长度; 长细比; 纤细; 名词; 细长

BNC.40473 / COCA.40756

英英释义

noun

• the property of an attractively thin person
  Synonym:slightnessslimness
• relatively small dimension through an object as opposed to its length or width
  1. the tenuity of a hair
  2. the thinness of a rope
  Synonym:thinnesstenuity
• the quality of being slight or inadequate
  1. he knew the slenderness of my wallet
  2. the slenderness of the chances that anything would be done
  3. the slenderness of the evidence

双语例句

• The calculation model of cable tension tested by frequency method for tied-arch bridge is analysed, the effects law of slenderness ratio on calculation precision are also analysed.
  对基于频率法测试系杆拱桥吊杆索力的计算模型的选用进行了研究，重点分析了吊杆长细比对模型计算精度的影响规律。
• On the Nose Profile Role and Slenderness Ratio of Projectile in Penetration Numerical simulation of penetration process for PELE projectile against target
  弹丸头部形状和长径比对侵彻过程的影响研究PELE弹侵彻过程壳体膨胀破裂的数值模拟
• Based on model experiment and simulated experiment, the formula of equivalent slenderness ratio was established.
  在模型试验和仿真试验的基础上，提出了单边连接高强角钢等效长细比公式。
• Excessive slenderness ratio of the steel pipe concrete piles, initial deflection and tie-in disfigurement will lead to the pile bodys instability and influence its carrying capacity.
  淤泥质土对桩身的侧向约束很弱，钢管混凝土桩的长径比过大、初始挠曲、接头缺陷都可能导致桩身失稳而影响其承载力。
• The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.
  结果表明，对其影响最大的为长细比，其次是轴压比，再次是含钢率。
• Volumetric efficiency, slenderness, span over length ratio increase with the cone angle.
  体积率、细长比和展长比都随着基本流场圆锥角的增大而增大。
• It is shown that the nonlinear frequency ratio increases with the vibration amplitude and the slenderness ratio.
  计算结果表明非线性频率与线性频率之比随振动幅值的增大和梁长细比的增大而增大；
• Some kinds of Newtons theory of collision methods is extended to calculate the supersonic and hypersonic missiles with large slenderness ratio.
  将牛顿碰撞类方法推广应用于超、高超声速细长体导弹的气动特性预测。
• This article presents a unified analysis of the limiting slenderness of plate elements of compression members with three commonly used sections.
  本文统一分析了轴心压杆三种常用截面的板件宽厚比限值。
• Bounds slenderness ratio among axial compression short columns, middle long columns and long columns were determined.
  确定了钢管煤矸石混凝土轴心受压短柱与中长柱以及中长柱与长柱的界限长细比；